Mr. Heater Plaque HSVFR10LP Operations Instructions download pdf (Page 10)

Installation Instructions and Owner’s Manual

Unvented Natural Gas Fired Room Heater

8. Turn off heater (see To Turn OFF Gas to Appli-

ance, page 10.

9. Replace lower front panel.

OPERATING YOUR HEATER

FOR YOUR SAFETY READ BEFORE LIGHTING

WARNING: If you do not follow these instructions

exactly, a re or explosion may result causing prop-

erty damage, personal injury or loss of life.

A. This appliance has a pilot that must be lighted

by hand. When lighting the pilot, follow these

instructions exactly.

B. BEFORE LIGHTING smell all around the appli-

ance area for gas. Be sure to smell next to the

oor because some gas is heavier than air and

will settle on the oor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electrical switch; do not use

any phone in your building.

• Immediately call you gas supplier from a neigh-

bor’s phone. Follow the gas supplier’s instruc-

tions.

• If you can not reach your gas supplier, call the

re department.

• Use only your hand to push in or turn the gas

control knob. Never use tools. If knob will not

push in or turn by hand, don’t try to repair it; call

a qualied service technician or gas supplier.

Force or attempted repair may result in a re or

explosion.

• Do not use this appliance if any part has been

underwater. Immediately call a qualied service

technician to inspect the appliance and to re-

place any part of the control system which has

been underwater.

LIGHTING INSTRUCTIONS

1. STOP! Read the all safety information included

with and on the side of heater.

2. Check that gas supply to heater is on.

3. Push in gas control knob and slightly turn clock-

wise to the OFF position (see gure 16).

Note: Knob cannot be turned from PILOT to OFF

unless knob is pushed in slightly. Do not force.

4. Wait ve (5) minutes. Then smell for gas, in-

cluding near the oor. If you smell gas, STOP!

Follow “B” in the safety information above. If

you do not smell gas, go to the next step.

5. Push in gas control know slightly and turn

counterclockwise to PILOT/IGN and depress

for ve (5) seconds.

Note: The rst time that the heater is operated after

connecting the gas supply, the control knob should

be depressed for about 30 seconds. This will allow

air to bleed from the gas system.

6. Push in control knob and rotate control knob

back to OFF position then rotate counterclock-

wise to PILOT/IGN position. This will light pilot.

If needed gently keep rotating control knob

back and forth while depressed until pilot lights.

7. Keep control knob depressed in for ten (10)

seconds after lighting pilot. If pilot goes out,

repeat steps 4, 5, 6 and 7.

If pilot does not stay lit, refer to Troubleshoot-

ing, pages 12-13. Also, contact a qualied

service person or gas supplier for repairs.

 If control knob does not pop up when released,

contact a qualied service person or gas sup-

plier for repairs.

8. FOR IR10NG: Turn control knob to “LO” to light

heater. Leave on “LO” position until the left

burner tile has turned bright orange.

After left burner tile has turned bright orange,

adjust heat output by turning Control Knob to

desired position (“LO” or “HI”). Note: Both tiles

turn orange only on HI setting.

FOR BF10NG: When the pilot is lit, turn the control

knob to “HI” position to light.

FOR BF10NG: After ame is established on “HI”,

adjust heat output by turning control knob to de-

sired position (“LO” or “HI”). Do not operate heater

between locked positions.

Figure 16

CAUTION: Do not try to adjust heating level by using

equipment shutoff valve.

WARNING: When running heater, set control knob

at “LO” or “HI” locked positions. Poor combustion

and higher levels of carbon monoxide may result

if heater is operated with control knob positioned

between locked positions.

IMPORTANT: Release downward pressure while turn-

ing control knob. Control knob must be locked at the

desired position.

TO TURN OFF GAS TO APPLIANCE

SHUTTING OFF HEATER:

1. Turn off equipment shutoff valve.

Control Knob

1 2 ... 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Mr. Heater Plaque HSVFR10LP Operations Instructions Page 10

Comments to this Manuals

Related products and manuals for Space heaters Mr. Heater Plaque HSVFR10LP