Mr. Heater Plaque HSVFR10LP Operations Instructions download pdf (Page 7)

Installation Instructions and Owner’s Manual

Unvented Natural Gas Fired Room Heater

1. Attach to wall studs

2. Attach to wall anchor

Figure 6

Attaching to Wall Stud:

This way is the best providing the strongest mounting in

wood frame houses.

Attaching to Wall Anchor:

This way allows you to attach mounting bracket to hol-

low walls (wall areas between studs) or to solid walls

(concrete or masonry).

Decide which way best suits your needs. Either method

will provide a secure hold for the mounting bracket.

1. Tape mounting bracket to wall where heater

will be located. Make sure mounting bracket is

level. For wall stud mounting locate one end of

the mounting bracket over a wall stud.

WARNING: Maintain minimum clearances

shown in gure 7. If you can, provide greater

clearances from the oor and joining wall.

2. Mark screw locations on wall (see gure 7).

3. Remove tape and mount bracket from wall.

Figure 7

Attaching to Wall Stud:

For attaching mounting bracket to wall studs

1. Drill holes at marked locations using 9/64” drill

bit.

2. Place mounting bracket onto wall. Line up

holes on each end of bracket with hole drilled in

wall.

3. Insert mounting screws through bracket and

into wall studs.

4. Tighten screws until mounting bracket is rmly

fastened to wall studs.

Attaching to Wall using Anchor:

For attaching mounting bracket to hollow walls (wall ar-

eas between studs) or solid walls (concrete or masonry)

Note: Wall anchors, mounting screws, and spacer

are in hardware package. The hardware package is

provided with heater.

1. Drill holes at marked locations using 5/16” drill

bit. For solid walls (concrete or masonry), drill

at least 1” deep.

2. Fold wall anchor as shown in gure 8 below.

Figure 8.

3. Insert wall anchor (wings rst) into hole. Tap

anchor ush to wall.

4. For thin walls (1/2” or less) insert red key into

wall anchor.

5. Place mounting bracket onto wall. Line up

holes on each end of bracket with wall anchors.

6. Insert mounting screws through bracket and

into wall anchors.

7. Tighten screws until mounting bracket is rmly

fastened to wall.

Placing Heater on Mounting Bracket

1. Locate two horizontal slots on back pane of

heater (see gure 9).

2. Place heater onto mounting bracket. Slide hori-

zontal slots onto stand-out tabs on mounting

bracket.

Figure 9

Installing Bottom Mounting Screws

1. Locate two bottom mounting holes. These

holes are near bottom on back panel of heater

(see gure 10).

Adjoining Wall

17-1/2” Min.

6-1/2” Min. 10,000 BTU

10-1/4” min 20,000-30,000 BTU

16” (Lg)

12-9/64” (Sm)

Mark mounting hole locations

and drill holes where indicated.

Allow for minimum clearances

Horizontal Slots

Mounting Bracket

mounted to wall

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Mr. Heater Plaque HSVFR10LP Operations Instructions Page 7

Comments to this Manuals

Related products and manuals for Space heaters Mr. Heater Plaque HSVFR10LP