Mr. Heater HST45 Operations Instructions download pdf (Page 11)

Operating Instructions and Owner’s Manual | Gas-Fired Low-Intensity Infrared Heater

MHT / HST HEATER ASSEMBLY INSTRUCTIONS

1. Place gaskets from Gasket kit (02885) on each side of the burner

box.

Use the four mounting studs around each of the three-inch

holes

for location.

Slide the tube flanges over the studs as was done in the prior

step

with the gaskets. The tube ends extend through the flanges

to help with alignment.

Using the four long and four short nuts from the bolt kit (02876)

secu

re the tube set to the burner box. As shown in the diagram,

use

the four long nuts in the center and the four short nuts on

the

outside.

Slide the bulkhead and reflector assembly forward until it stops

the long nuts. Using the (4) 5/16-18 X 1/2" long screws from

the

(02876) bolt kit secure the bulkhead to the burner box.

USE CAUTION AS NOT TO

OVERTIGHTEN ASSEMBLY AS IT

MAY CAUSE DAMAGE TO PARTS

ASSEMBLY

Enerco Group, Inc.,

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

No comments

Mr. Heater HST45 Operations Instructions Page 11